Installation Instructions for Part #: KPS01 - KPS07 Karcepts A/C & P/S Removal Kit (With Alternator Relocation)
5. TENSIONING THE BELT (continued…) 4. If not using a belt tension gauge, a good rule of thumb is to apply 20lbs. of force in between the idler and
CONGRATULATIONS! YOUR A/C AND P/S REMOVAL IS NOW COMPLETE!!!
Disclaimer/Warranty: Due to the nature of high performance applications, Karcepts, Inc. products are sold without any warranty of merchantability or
Parts Included With A/C & P/S Removal Kit DESCRIPTION QTY ALTERNATOR RELOCATION BRACKET 1 M10X40 FLANGE BOLTS (HONDA PART #: 95701-10040-08) 2
1. POWER STEERING PUMP REMOVAL 1. Remove the high pressure and return hoses from the power steering pump, and drain all fluids. 2. R
2. A/C COMPRESSOR REMOVAL 1. Remove all A/C lines and unbolt the compressor from the engine. Recover the refrigerant with a recovery/recycling/char
3. ALTERNATOR RELOCATION 1. Secure the alternator relocation bracket with the two M10 x 40mm long flange bolts (Honda Part #: 95701-10040-08). Torq
3. ALTERNATOR RELOCATION (continued…) 4. Insert the M8 x 100mm long flange bolt into the top hole of the alternator, then slide the 1/2” thick alter
4. TENSIONER INSTALLATION 1. Affix the tensioner bracket to where the alternator previously mounted on the water pump housing with one M8 x 65mm lon
4. TENSIONER INSTALLATION (continued…) 4. Wrap the 6 rib belt around the pulleys as shown while sliding the idler pulley onto the tensioner block.
5. TENSIONING THE BELT 1. Loosen the button heads which were previously snugged such that the tensioner block will move up and down freely within th
Kommentare zu diesen Handbüchern