Karcepts KSM01 Bedienungsanleitung

Installation Instructions for Part #: KSM01 Shifter Mounting Kit for K-Series powered 92-00 Civics (non-Del Sol) &a

2. MODIFYING YOUR CHASSIS (continued…) 14. Now that everything lines up, you can mark your chassis for cutting. Remove the shifter mount and rear b

3. MOUNTING THE SHIFTER 1. Re-attach the rear mount bracket following step 9, from MODIFYING YOUR CHASSIS. Apply a liberal amount of the silicone s

3. MOUNTING THE SHIFTER (continued…) 4. Bolt the JDM shifter box to the shifter mount using four 1/4" cap screws (3/4” long), 1/4” lock washers

3. MOUNTING THE SHIFTER (continued…) 6. Install the cable cover plate with 1/4" cap screws (3/8” long) and 1/4" lock washers. The cable c

4. RUNNING THE CABLES When using an EG/DC2 crossmember, run the cables underneath of the crossmember and into the engine bay. You should be able to

5. FINAL CHECKS/SEALING Before installing your center console or sealing the mount completely, you will need to make certain you can shift through al

CONGRATULATIONS! YOU NOW HAVE ONE OF THE CLEANEST LOOKING K-POWERED VEHICLES AROUND!

Legal Disclaimer: Parts sold or manufactured by Karcepts, Inc. may not meet legal requirements for use on public roads. It is the user’s responsibil

Parts Included In Shifter Mounting Kit DESCRIPTION QTY SHIFTER MOUNT 1 REAR SHIFTER MOUNT BRACKET 1 LEFT FRONT SHIFTER MOUNT BRACKET 1 RIGHT FRONT

1. MODIFYING THE FACTORY RSX SHIFTER Remove the material from the plastic base of the factory RSX shifter box as shown below (hatched areas). This i

2. MODIFYING YOUR CHASSIS 1. Cut out the hatched areas of the provided template as shown below. You can fold the template about the cr

2. MODIFYING YOUR CHASSIS (continued…) 4. To confirm position of the holes just drilled, use the rear shifter mount bracket along w/ the provided M8

Left side of chassis tunnel 2. MODIFYING YOUR CHASSIS (continued…) 5. Temporarily affix the template by threading the M8 cap screws into the welded

2. MODIFYING YOUR CHASSIS (continued…) 7. Center punch and drill two 9/32” holes where you had marked in step 6. If using a chassis th

2. MODIFYING YOUR CHASSIS (continued…) 9. Temporarily install the rear shifter mount bracket underneath the vehicle with two M8 cap screws, M8 lock

2. MODIFYING YOUR CHASSIS (continued…) 11. Hand tighten the shifter mount to the rear mount bracket utilizing two of the 1/4" cap screws (1/2”